Microtel DialStat (With Fault Indicators) Manual de usuario descargar pdf (Pagina 23)

MICROTEL DialStat

TROUBLESHOOTING:

Symptom: Unable to place telephone calls (Line LED comes on but no ring at called

telephone number).

Cause: Phone number not entered correctly.

Cause: Call being placed to different number than expected.

Cause: Phone line not plugged-in, phone line broken or in use.

Cause No touch-tone service,use pulse method by pre-pending *1 to each phone

number

Symptom: Unable to program with local telephone.

Cause: External 12 VDC power required. (Green AC power/charging LED must be on)

Cause: Incorrect command format (all commands begin with * or **). To clear out the

message buffer at any time, press the ‘#’ key.

Cause: Touch-tone phone must be used (listen for tones when keys are pressed).

Cause: Phone not plugged in correctly (local telephone must be plugged into PHONE

jack, and OFF HOOK LED should be on).

Cause: Dialer off-hook placing call (RING/ACTIVE LED is on).

Cause: Very loud or noisy environment -- program from remote phone or use a mute

button on the local phone.

Symptom: Not placing alarm call (RING/ACTIVE LED does not come on).

Cause: Fault input not really in alarm or is not a new alarm. FAULT LED should blink.

Cause: Alarm delay is too long. Try setting a shorter Fault Delay period.

Cause: Local telephone is off-hook. Is OFF HOOK LED ON? This halts the dialer.

Cause: Intercall (Snooze or Call-spacing) delay set. Dialer waits before next call.

Cause: No telephone numbers to call. Review telephone numbers.

Symptom: Dialer is dead (AC POWER LED is off).

Cause: Check power to dialer. Make sure it is wired properly.

Cause: No external power and internal battery is dead.

Symptom: Dialer is dead (AC POWER/CHARGING LED is ON, Power switch is ON)

Cause: Review all System and Fault Input configuration, and Telephone Numbers.

Nonvolatile data may have been corrupted, not entered, or incorrectly entered.

Enter *00- The dialer will recite the status of the dialer then “Data Error”

indicating corrupted nonvolitale parameters.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Sin comentarios

Microtel DialStat (With Fault Indicators) Manual de usuario Pagina 23