Microtel DialStat (With Fault Indicators) Manual de usuario descargar pdf (Pagina 17)

MICROTEL DialStat

z Answer Delay The number of rings the dialer will see before answering an incoming

call.

*02 Review answer delay

**02nn Program answer delay

Example- Command: **0205

Response: The answer delay is zero five.

z Access Code This 2 digit access code is required to access configuration commands

during a telephone call to or from the dialer.

*03 Review value of access code

**03nn Program access code

NOTE: The factory set default code is ‘12’. Use a 00 access code value to disable

access code requirement. Access code is not required to configure the dialer through

the local PHONE jack.

Example- Command: **0313

Response: The access code is one three.

z Snooze Delay The snooze delay is the time, in hours, after which the dialer will re-

arm an acknowledged alarm and begin calling again as a reminder that the alarm

condition still exists.

*04 Review snooze delay time interval

**04HH Program snooze delay time interval

Example- Command: **0412

Response: The snooze delay is one two.

z Firmware Version

*05 Report Firmware Version

Response will play back all resident vocabulary, then Speak “Number 14”, where 14 is

the current Firmware version.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Sin comentarios

Microtel DialStat (With Fault Indicators) Manual de usuario Pagina 17