Microtel DialStat (With Fault Indicators) Manual de usuario descargar pdf (Pagina 21)

MICROTEL DialStat

calling the dialer: The dialer will speak a voice message of system name and current

alarms or normal status. It will also report the current temperature and local output state

IF the local output has been manually controlled.

z System Status Gives a complete status of all points monitored by the dialer

*00 Report system status

Example- Command: *00

Response: MICROTEL DIALSTAT Channel one normally closed

digital input in alarm. Temperature is seven eight degrees.

The local output is open.

Controlling the local output relay

DialStat

has a set of output contacts that may be controlled from a touch-tone phone.

These contacts may be used to turn ON or OFF external equipment, or as a signal input to

another device. Simply enter the following command during a phone call to or from the

dialer, via either the phone or cellular connection.

NOTE: de-energized state is open.

*06 Review local output configuration

**06 0/1/2 Configure/Control local output

Example- Command: **060

Response: The local output is closed.

Example- Command: **061

Response: The local output is open.

Example- Command: **062

Response: The local output is fault status

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Sin comentarios

Microtel DialStat (With Fault Indicators) Manual de usuario Pagina 21