Microtel 100 Dialer Series Información técnica descargar pdf (Pagina 18)

MICROTEL CellStat

z Answer Delay The number of rings the dialer will see before answering an incoming

call on the telephone line.

*02 Review answer delay

**02nn Program answer delay

Example- Command: **0205

Response: The telephone answer delay is zero five rings.

z Access Code This 2 digit access code is required to access configuration commands

during a telephone call to or from the dialer.

*03 Review value of access code

**03nn Program access code

NOTE: The factory set default code is ‘12’. Use a 00 access code value to disable

access code requirement. Access code is not required to configure the dialer through

the local PHONE jack.

Example- Command: **0313

Response: The access code is one three.

z Snooze Delay The snooze delay is the time, in hours, after which the dialer will re-

arm an acknowledged alarm and begin calling again as a reminder that the alarm

condition still exists.

*04 Review snooze delay time interval

**04HH Program snooze delay time interval

Example- Command: **0412

Response: The snooze delay is one two hours.

z Firmware Version

*05 Report Firmware Version

Response will play back all resident vocabulary, then speak “Cell Stat number one zero”,

where “one zero” is the current Firmware version (e.g. 1.0).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

Sin comentarios

Microtel 100 Dialer Series Información técnica Pagina 18