Microtel 100 Dialer Series Manual de usuario descargar pdf (Pagina 21)

MicroWin 2000EX Manual

The channel is setup to follow another channel’s state. Its state depends on the channel that

it’s following.

Type

This tells the type of this channel.

Digital Types:

DI NO Digital Input Normally Open

DI NC Digital Input Normally Closed

DO Digital Output

DO LA Digital Output Local Alarm

Power Power Fail (Normally Closed)

Digital Output Follow Types:

FNone Follow None – Follow Disabled

Fx Follow Channel x State

FxFault Follow Channel x Fault Condition

FxAlarm Follow Channel x Alarm Condition

FxFill Follow Channel x – Fill Algorithm (Close at Low Setpoint, Open at High Setpoint)

FxEmpty Follow Channel x – Empty Algorithm (Close at High Setpoint, Open at Low Setpoint)

Analog Types:

AO Analog Output

AI Analog Input

For a full description of each of these channel types, see section Editing an I/O Point.

State

The channel status information is shown according to how the dialer channel was setup. If it is an

analog channel, it will be the scaled value. If it is a digital channel, the label for whether it is

Opened or Closed will be displayed.

If it is a follow channel type and the state is closed, the state will be displayed in red; otherwise, it

will be displayed in black.

Runtime:Day:Hour:Minute

This tells the Runtime value of the channel. Runtime represents the total length of time that this

channel has been in a fault state.

Counter

This tells the current Counter value of the channel. Counter counts the number of transitions

from a normal state to a fault state.

Alarm Time: Day: Hour:Minute

This tells the current Time In Alarm value of the channel. Time In Alarm represents the current

length of time that this channel has been in a fault state.

Latch

For a Call On Alarm Input channel, it tells if an alarm state is currently latched in or not. If so,

‘Yes’ will be shown. For a Digital Output channel, it tells if the output is a latched or a

momentary output. If it is a latched output channel, it will show ‘Yes’.

Reset Cnts: This resets the counter and the runtime back to zero.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 62 63

Sin comentarios

Microtel 100 Dialer Series Manual de usuario Pagina 21